Re: [Jack-Devel] what could cause: "impossible sample width (1) discovered!"

>>> i did some testing with arecord but i do
>>> not fully understand the outputs.
>>
>> arecord's default is 8-bit samples at 8 kHz.
>> When not supported by the hardware, ALSA automatically
>> converts the sample format.
>>
>>> As i understand it, my hardware is able to
>>> send 16bit. Maybe i do have to make some
>>> alsa configurations?
>>
>> Jack should be able to use 16 bits.
>> Please show your exact jackd command line.
>
> This is what qjackctl says:
> /usr/bin/jackd -dalsa -dhw:1 -r48000 -p256 -n3 -C -Xseq
>
> i also tried all other possible -p settings

ooh, seems it would work if i implement the outputs.
i tested this on my built in soundcard and it did produce
the same error unless i leave out -C if i start jack.  So
i hope it will work when my card is capable to support
duplex mode - i'll try to implement that feature now,
but maybe i'm too tired to get it working today. ^^
hmm, i think it should work with -C, shouldn't it?

Felix

1300131305.6463_0.ltw:2,a <AANLkTimOOefVeQ8U1K+maXDsfQK1fjW6OXTzuf5t_B-W at mail dot gmail dot com>