Re: [Jack-Devel] Using Jack
On 02/20/2011 12:00 PM, Dragan Noveski wrote:
>>>
>>> ALSA: cannot set hardware
>>> parameters for playback
>>>
>
> playback this is where your probem is....
> are you sure that you are using the right device (hw:0) ?
>
> in qjack you click the 'configuration' button, which will open a
> config window for you.
> there you could try sth different than hw:0. look at the input/output
> device or click at the '>' buttons to choose one.
>
> the output of the command:
>
> cat /proc/asound/cards
>
> could also tell us more.
>
OK Dragan, here it is:
# cat /proc/asound/cards
0 [Mia ]: Echo_Mia - Mia
Mia rev.1 (DSP56361) at 0xfe900000 irq 17
& as to the i/o settings, I've tried every parameter combination I had
(or could think of), & all with more or less the same result (jack will
not start). I think they were, when all worked, at 'default,' which was,
I think 'hw:0' (not really sure right now if input needed to be
different than output (?)).
Thanks again for helps here, hope this is some (further) help.
Henry
1298222967.21059_0.ltw:2,a <4D614F5F.6000304 at jamadots dot com>